01
Licensed & Insured Independent Pros
Calls go to independent contractors carrying liability coverage and licensing where required, including those who work with builders on new construction.
24/7 Foundation Water Line
Foundation Waterproofing in Westwood, PA
From new-construction membranes to retrofits on older Westwood homes, one call connects you with a licensed, insured independent pro who keeps water out of the foundation itself.
Call +1-866-476-1348Free call, any hour
- True waterproofing membranes, not just damp-proofing
- New builds and existing homes
- Upfront written quotes
- Free referral service
- Licensed and insured independent pros
- Written quotes before work
- Phones answered 24/7
The Problem
Damp-Proofing Isn't Waterproofing
Many builders apply only a thin asphalt damp-proofing coat, which code allows but which doesn't stop water under pressure. Damp-proofing slows vapor. It doesn't bridge cracks, and it breaks down over time in wet soil. Once the soil around the house saturates, water pushes through shrinkage cracks, tie-rod holes, form joints and pipe penetrations.
Block foundations add another weak point. The mortar joints and hollow cores soak up moisture, which shows up as white efflorescence, peeling paint and a constant damp feel. Proper foundation waterproofing turns the wall into a real barrier with membranes and drainage built for water pressure.
For new homes, it's far cheaper to do it right before backfill. For existing homes, contractors can excavate and retrofit, or combine targeted exterior work with interior drainage.
- Weeping at tie-rod snap-ties
- Moisture at pipe and utility penetrations
- Efflorescence and wicking on block walls
- New builds before backfill
Matching the Waterproofing System to the Soil
The site decides the system. A house on sandy, well-drained soil with a low water table needs good protection and a working footing drain, but it isn't fighting constant pressure. A house on dense clay, a low lot or a site with a seasonal high water table has water sitting against the wall for weeks. That second house needs a heavier membrane, a drainage board with real flow capacity and a footing drain that can keep up.
Fluid-applied membranes are the most common choice for residential work. They go on seamless, wrap around tie-rods and penetrations, and bridge hairline cracks. The key quality check is thickness: the crew should measure wet film thickness as they go, because a membrane applied too thin won't perform as rated.
Commercial foundations and tough sites often get sheets or bentonite. Sheets give a consistent factory thickness, which helps on large wall areas. Bentonite swells when it gets wet and seals small gaps on its own, though it needs to be confined by backfill to work properly.
No membrane works well without drainage. Drainage board and a footing drain take the pressure off, so the membrane only has to deal with water that's already moving away. Skipping drainage to save money is one of the most common reasons foundation waterproofing fails early.
Cost depends mostly on access and depth. On new construction, with the walls already exposed, you're paying for materials and application. On an existing home, excavation, hauling, shoring for deep trenches and restoring landscaping usually make up the larger share of the bill. A contractor should break those pieces out separately so you can see where the money goes, and so you can compare a full-perimeter job against sealing only the walls that actually leak.
Why Choose Us
Why Homeowners Call Us for Foundation Waterproofing in Westwood, PA
Foundation waterproofing is a materials job as much as a labor job.
02
Upfront Flat-Rate Pricing
Pricing is written by wall section or linear foot, with membrane type, drainage board and footing drain called out separately.
03
Fast Local Dispatch
Local contractors can fit tight construction schedules and respond fast to active leaks.
04
Specialized Tools & Equipment
Airless spray rigs for fluid-applied membranes, wet film thickness gauges, pressure-wash surface prep and low-pressure injection kits for penetrations.
Solutions
What Proper Foundation Waterproofing Includes
Each layer does a specific job. Together they keep the wall dry.
01
Spray-Applied Waterproofing Membranes
A thick, seamless rubberized asphalt or polymer membrane is sprayed or rolled onto the cleaned wall at a specified mil thickness. It stretches to bridge small cracks that would split ordinary damp-proofing.
02
Self-Adhered Sheets and Bentonite Panels
Self-adhering sheet membranes give a consistent factory thickness, and bentonite clay panels swell when wet to seal themselves. Both are common on commercial foundations and high water table sites.
03
Dimpled Drainage Board
Drainage board shields the membrane and channels water straight down to the footing drain instead of letting it sit against the wall.
04
Footing Drain Installation
A gravel-bedded, filter-wrapped drain at the footing carries water away so the membrane isn't holding back a saturated trench.
05
Tie-Rod and Penetration Sealing
Tie-rod holes, pipe sleeves and conduit entries are the most common leak points in poured walls. Contractors seal them with hydraulic cement, polyurethane injection or flexible sealant collars.
06
Block Foundation Treatments
A cement parge coat fills block joints and gives the membrane a solid, smooth surface to bond to.
Common Mistakes That Lead to Foundation Leaks
Most foundation waterproofing failures trace back to a handful of shortcuts. The first is skipping surface prep. A membrane applied over dirt, loose parging or form release oil won't bond, and water gets behind it within a few seasons. The second is applying it too thin. Fluid membranes are rated at a specific thickness, and a crew in a hurry can easily put on half that.
The third is leaving out the drainage board, which lets sharp backfill puncture the membrane and leaves water pressing against the wall instead of draining down. The fourth is a footing drain with no outlet, or one that discharges into a spot that floods. The last is backfilling with the same clay that came out of the hole, which holds water against the wall. A contractor who explains how they avoid each of these is one who has seen what happens when they're ignored.
On an existing home, ask the contractor how they'll protect the membrane during backfill, where the footing drain will discharge and how the final grade will slope. Those three answers tell you more about the quality of the job than the brand name on the membrane bucket.
How It Works
How a Foundation Waterproofing Call Works
Here's the sequence from the first call to backfill.
- 1
Call Dispatch
Call +1-866-476-1348 and tell us whether it's new construction or an existing home, and where you're seeing moisture.
- 2
Rapid Mobile Arrival
A local independent contractor schedules a site visit, coordinating with your builder if the walls are still exposed.
- 3
Expert Assessment & Quote
The contractor inspects the walls, checks soil and drainage conditions, recommends a membrane system and gives you a written quote.
- 4
Resolution & Final Walkthrough
The wall is prepped and sealed, drainage board and footing drain go in, and the contractor documents the work before backfill and reviews the warranty with you.
Building new? Ask for photos of the membrane and drainage board before backfill. Once the trench is filled, nobody can check the work again.
Keep Water Out of the Foundation Itself
One call connects you with a local independent pro who seals foundations below grade.
Call +1-866-476-1348Customer Stories
What Westwood Homeowners and Builders Say
Our builder planned on damp-proofing only. We upgraded to a membrane and drainage board, and the basement has stayed dry since day one.
Jordan P., Westwood
Water came in at three tie-rod holes every time it rained. The contractor injected each one from inside and the leaks stopped. Simple fix, fair price.
Mei L., Westwood
Our old block foundation was always damp and chalky. They excavated one side, parged it, put on a membrane and new footing drain. Night and day difference.
Carl B., Westwood
Clear quote, showed up when promised and sent pre-backfill photos without me even asking.
Ana V., Westwood
FAQ
Common Foundation Waterproofing Questions
What's the difference between damp-proofing and waterproofing?
Damp-proofing resists moisture vapor only. Waterproofing uses thicker, flexible membranes designed to stop liquid water under hydrostatic pressure.
Can an existing foundation be waterproofed from the outside?
Yes. The contractor excavates to the footing, cleans and repairs the wall, then applies a membrane, drainage board and footing drain before backfilling. It's more involved than interior work but stops water at the source.
How long does a foundation membrane last?
Quality membranes protected by drainage board are generally expected to last for decades. Ask the contractor for the manufacturer's rated lifespan and the written warranty terms.
Is foundation waterproofing worth it on new construction?
Yes, because the expensive part, excavation, is already done. Retrofitting later costs far more.
Can tie-rod leaks be fixed without digging?
Usually, yes. Tie-rod holes and small penetrations are often sealed from inside with injection. If many points leak, a broader solution may be more cost-effective.
Does foundation waterproofing require a permit?
It depends on your local building department and the scope. Excavation, drainage tie-ins and structural repairs are the most likely to need one, so ask the contractor who handles it.
Service Area
Foundation Waterproofing Coverage In and Around Westwood
Calls from all over Westwood and nearby areas reach local independent contractors who seal foundations below grade. That covers new construction, additions and existing homes.
Check the list below or call to ask about your area.
